The Josh Keyes Thread

[RambosRemodeler]

Mine just showed up, and required signature too. Never received shipping notice.

-bontakun

Thanks

-Rambosremodeler

[bubbie]

luls

-bubbie

[rubberneck]

Suspense is killing me

-RN

[ToolFanFromWayBack]

-TFFWB

[trarex]

You guys act so immature sometimes



-trarex

[sixstringer]

Follow up....after a day of flattening.

Yesterday

JK3.jpg

1 day later

day2.jpg

day2_1.jpg

The roll bend is still there but getting better.

[sixstringer]

Doesn't really matter though cause now that I've had a chance to inspect it I noticed this.

datedge.jpg

I'm trying to decide whether or not that's being too nit picky???

[khetti]

Very slight roll bend in the middle of mine, but not as bad as I am seeing in others luckily. I think it will flatten out OK...

[alittle]

I'm trying to decide whether or not that's being too nit picky???

On a giclee direct from the releasing gallery? No.

Would probably spoon out though.

[trarex]

apparently 2 day priority means something else to them
I pray for it

Capture 4.PNG

[partpat]

So much fail on a piece this small and a release managed so poorly.

Anyone w any damage, roll bends etc be as picky as you would if you bought secondary at least the gallery could make this right if they cared.

[stuckeyc]

I got lucky, perfect shape and nice low number taboot.

[Origo]

Sorry for all those who received damaged prints, hopefully the gallery will come up with a good solution for all.

[geebee]

Mine arrived in the same condition - not a crease, but very significant bend like sixstringer's. I flattened it normally overnight and then gave it a slight reverse roll. Flattened again for a few hours and it looks much better. With a mat, it will be fine.

- geebee

[rubberneck]

The very fact that this doctoring has to be done is reason enuff to return it and send a message to the gallery.

Mint or return imo. I'll expect a shipping label as well, not going to be out of pocket for their incompetence.