Floating a Print
A lot of people on EB have been asking about floating prints so I thought I would document one method. I’ll be doing a reinforced floating pendant hinge. This is not the only method to float a print but it is a great method particularly with large prints.
The three prints I am planning to float and frame are Shepard Fairey’s Peace Series. I’m going to float them on an archival mat with a 1 inch border all around. And then frame them in simple walnut gallery frames with wood spacers.
I’ve chosen a mat that matches the color of the paper. I position the print the on the mat and hold it in place with a weight bag (the weight bag is resting on a few sheets of reemay fabric to protect the print). I put down sticky notes on the top corners so I can remove the print but have a reference of where the print will eventually be.
Once I remove the print I use a surgical knife to cut two tiny slits approx 1 inch long and 1/16 of an inch wide. Once I have the Mulberry paper glued to the back of the print it will be threaded through the slits and glued to the back of the mat board.
The three prints I am planning to float and frame are Shepard Fairey’s Peace Series. I’m going to float them on an archival mat with a 1 inch border all around. And then frame them in simple walnut gallery frames with wood spacers.
I’ve chosen a mat that matches the color of the paper. I position the print the on the mat and hold it in place with a weight bag (the weight bag is resting on a few sheets of reemay fabric to protect the print). I put down sticky notes on the top corners so I can remove the print but have a reference of where the print will eventually be.
Once I remove the print I use a surgical knife to cut two tiny slits approx 1 inch long and 1/16 of an inch wide. Once I have the Mulberry paper glued to the back of the print it will be threaded through the slits and glued to the back of the mat board.
I tear the appropriate size pieces of mulberry paper. You want to tear the pieces (not cut them) so you have all the fibers along the edges so it grips better when glued. I use the blade to cut straight edges on a few pieces that will be used for reinforcement.
I use a flat tipped brush and paint excess wheat paste off the brush on so I’m only transfers a very delicate amount onto the mulberry paper. I don’t want it to be too thick or it might warp the paper.
Once the mulberry hinges are glued down I place a sheet of reemay over it. And a piece of plexi to weigh it down. And allow it to dry for approx 20 minutes. Reemay fabric used as a drying support and wheat paste and mulberry paper don’t adhere to it.
Once everything is dry I glue in a large reinforcement piece of mulberry paper. This piece is torn on three edges and cut along the top edge which will rest across the fold. Again you allow all the reinforcement pieces to dry for approx. 20 minutes.
The mulberry paper is slowly threaded through the slit and pulled until it is completely threaded through.
The print and mat are then turned over again and placed face down in preparation of gluing the mulberry paper to the back of the mat.
Here you can see the finished, dried result of the hinge with the reinforcement piece glued over it.
Here are all three prints floating on their mats with a 1 inch border.
The newly hinged art and backing are placed in the frame.
These frames have a wooden strainer that hold everything in place.
I'll take some more detailed photos tomorrow and post them. They are hung up in a hallway so it was difficult getting a good shot of the three of them together since the space is tight. I'll pull one off the wall tomorrow and do some better photos.
It actually isn't that hard if you know the steps. Kind of like cooking a meal - if you follow the recipe correctly it comes out fine in the end.trarex wrote:Thats really awesome of you to share your knowledge and expertise.
Great step by step. You make it look easy enough that I could do it.
But I know better.