Switching Prints in Frame: Flex Points
So any getting a quote from a local toronto area framer I asked if there was a way to frame which would allow me to switch prints in and out at my leisure and I was told they could offer me this by using "flex points". They did not recommend this option however because apparently it can lead to dust getting into the frame much easier. Just wondering if any of you have heard of this method and your opinion on it? Thanks guys
Flex Points are just flexible points from a point driver. Kind of like flat nails that can bend. I think they're suggesting that you then bend the points back, remove the backing, mat and art and replace it with your new art. It's not really that practical if they cut the backing and mats the appropriate size it's a tight squeeze to pull it all out while still leaving the (bent) points in. Google "Framing Point Gun" and you'll understand better what they are proposing.
If you're using a deeper frame a better alternative (though more expensive) might be to use a strainer to hold the art, mat and backing in the frame. Strainers screw into the frame. So when you're ready to switch the art out you simple unscrew the strainer. It fits more flush into the back and thus helps eliminate dust creeping into the frame.
If you're using a deeper frame a better alternative (though more expensive) might be to use a strainer to hold the art, mat and backing in the frame. Strainers screw into the frame. So when you're ready to switch the art out you simple unscrew the strainer. It fits more flush into the back and thus helps eliminate dust creeping into the frame.
Those points will also break if you bend them back and forth too many times.
"I see dudes using cotton gloves on prints that I know were printed while someone was drinking a beer or eating Cheetos, while water leaked from the ceiling. And I'm not even talking about my shop!" - alexfugazi
They make two different types of points. Rigid points and flexible points. The flexible points are obviously the ones meant to use if you plan on bending. And if you do plan on switching prints in and out a lot it might be worth investing in your own point gun.KSUvet wrote:Those points will also break if you bend them back and forth too many times.