DIY Print Rack
- danielrolnik
- Art Connoisseur
- Posts: 846
- Joined: Wed Sep 04, 2013 7:59 pm
- Location: Los Angeles, CA
- Contact:
Does anyone have plans they've used to construct their own Print Rack?
- danielrolnik
- Art Connoisseur
- Posts: 846
- Joined: Wed Sep 04, 2013 7:59 pm
- Location: Los Angeles, CA
- Contact:
I'm thinking of building something like this with 2x4's, plywood, and nails. Then I would stain it. The front gate would be slightly smaller, which is why it would require the trapezoid shape base.
- DonPiano
- Art Expert
- Posts: 8473
- Joined: Thu Jan 31, 2013 8:42 am
- Location: Perth, Nowhere Australia.
Like to stand prints in?
The Curb
Friends and Like-Minded Souls of webuyyourkids Facebook Group
Hotdogs are not sandwiches.
Friends & Family don't let Friends & Family send money via Friends & Family.
Friends and Like-Minded Souls of webuyyourkids Facebook Group
Hotdogs are not sandwiches.
Friends & Family don't let Friends & Family send money via Friends & Family.
- DonPiano
- Art Expert
- Posts: 8473
- Joined: Thu Jan 31, 2013 8:42 am
- Location: Perth, Nowhere Australia.
I've always liked the idea of these racks, but the only problem is when it comes to standing the prints up with foam core is that the heavier inked prints would fall down pretty easily.
The Curb
Friends and Like-Minded Souls of webuyyourkids Facebook Group
Hotdogs are not sandwiches.
Friends & Family don't let Friends & Family send money via Friends & Family.
Friends and Like-Minded Souls of webuyyourkids Facebook Group
Hotdogs are not sandwiches.
Friends & Family don't let Friends & Family send money via Friends & Family.
- danielrolnik
- Art Connoisseur
- Posts: 846
- Joined: Wed Sep 04, 2013 7:59 pm
- Location: Los Angeles, CA
- Contact:
The narrow bottoms make it so only a few will fit in them too. I'm trying to figure out a good solution for that. Also, thinking of making a wall-mounted version. Have you seen one like that?DonPiano wrote:I've always liked the idea of these racks, but the only problem is when it comes to standing the prints up with foam core is that the heavier inked prints would fall down pretty easily.